Luxul XWR-1750 Manuel d'utilisateur télécharger pdf (Page 52)

XWR-1750

a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450

LUX-UG-XWR-1750 Vers: 022515

APPENDIX 1: COMMON COMMANDS

Common Commands Description

Cmd

Enter the command line mode of a Windows system (applicable to

Windows2000 and higher).

ipconﬁg

Displays the IP address of any network adapters on the computer. (i.e.

ipconﬁg /all) Must be run from the command line.

Ping

Used to test for network connectivity and device/system recognition.

A device sends a packet to the target host and asks for a response. If

the device receives a response from the target host, it can then see

the network response time and connection status between the local

device and target host. (i.e. ping 192.168.0.1) Must be run from the

command line.

netstat

Displays details of active network connections including routing table

and network interface information. Can also be used to count the

active network connections. Must be run from the command line.

Tracert

Displays the path taken by a packet before reaching the target host

and the speciﬁc time when it reached each node. Similar to the Ping

command, but provides more detailed information. Displays the entire

path and IP address of each node in the path and total elapsed time.

Must be run from the command line.

1 2 ... 47 48 49 50 51 52

Pas de commentaire

Luxul XWR-1750 Manuel d'utilisateur Page 52